Possible to use Obi100 as second phone port to Obi200?

(1/3) > >>

sportflyer:
I have configured Obi200 with GV on SP1 and it's functioning  well.

Now I have a Obi100  that is "obsolete" as far as GV is concerned. Instead of trashing the Obi100 can I use it in conjunction with Obi200 as a second phone port to the Obi200?

If so , whats the connection between the 2 units ? Also how to configure Obi200 so that incoming calls on SP3 ( with GV#2 ) are routed to OBi100 phone port?  and vice versa?

Thanks

azrobert:
http://www.obitalk.com/forum/index.php?topic=14451.msg92276#msg92276

sportflyer:
Two questions:

1) I assume I have to reset the Obi100 before deploying it because the original was configured for GVGW ?  How to reset and not loose the last firmware update ?

2) Connect the Obi100  to router same as Obi200

Thanks

azrobert:
1. You don't need a reset. Just delete SP1 using the OBiTalk dashboard then use OBi Expert to make the config changes.

2. This method uses the OBiTalk network to transfer calls between the 2 boxes, so the OBi100 can be connected to a router located in another network or a router on the same network.

sportflyer:
Quote from: azrobert on July 20, 2018, 04:54:47 pm

1. You don't need a reset. Just delete SP1 using the OBiTalk dashboard then use OBi Expert to make the config changes.

2. This method uses the OBiTalk network to transfer calls between the 2 boxes, so the OBi100 can be connected to a router located in another network or a router on the same network.



I have removed Obi100 from my Obitalk dashboard before I added the Obi200.  This means I have to add Obi100 device back to the obi dashboard for the method to work .

Navigation

[0] Message Index

[#] Next page