If You Buy Premium Support, will the obi202 updates automatically install?
drgeoff:
Quote from: ascendedmind on July 29, 2018, 03:42:57 pm
FUBAR:
"The firmware version is not read out when you press keys to enable access to the onboard management interface via the INTERNET port." Does not work if I enable or disable WAN or use of Internet or WAN port as described very FAQ.
Internet or WAN port, results in "The webpage cannot be found" or The requested URL was not found!
This should be an easy fix, however it has turned very convoluted. >:( :( :-[
1. Enable access as per the FAQ.
2. Dial ***1 and note the IP address that is read out to you.
3. Point a browser at that address.
ascendedmind:
I already did that, several times. Should not typing in the ip address into the browser immediately open the OBihair page? It has not. Even after following the instruction. It must be something simple, causing this issue.
Shall I use the WAN port & enable it or Internet port?
Remember neither has worked. I did exactly as you previously said. I will repeat again.
drgeoff:
Quote from: ascendedmind on July 29, 2018, 04:09:56 pm
I already did that, several times. Should not typing in the ip address into the browser immediately open the OBihair page? It has not. Even after following the instruction. It must be something simple, causing this issue.
Shall I use the WAN port & enable it or Internet port?
Remember neither has worked. I did exactly as you previously said. I will repeat again.
Connect your computer to your router as usual. Connect the OBi's INTERNET port to a LAN port on your router.
Enabling access from the INTERNET port only needs to be done successfully once. That setting will remain until deliberately changed back or the OBi is reset to defaults.
Dial ***1. What IP address is read out? There is no security risk to reveal that here.
Point a browser at that address. You should be prompted for login details.
ascendedmind:
Here's the info you requested:
http://192.168.2.102/
I simply copy & pasted into firefox, chrome & Internet explorer & nothing happens, but this:
The requested URL was not found!
ascendedmind:
drgeoff, if I disable Internet (WAN) port access, does that automatically active internet port access?
The WAN port is disabled, shall I turn back on?
My OBi202 is plugged into the internet port on OBi202 to WAN port on Medialink Router
Navigation
[0] Message Index
[#] Next page
[*] Previous page