800 calling through SipBroker (via CallCentric)
mo832:
The number was rejected by the service provider. Reason 404.
I have tried this with various other strings given by RonR on other threads. Something like **275*x. or [x*][x*]. Same error every time. The voice message reads back the full key entry exactly as I dialed it, which should work.
But, if I place the FULL number in a speed dial like SP1(**275*18001234567), it will dial the number and complete the call.
What gives? ???
azrobert:
Please post your full ITSP A DigitMap
mo832:
Currently from ITSP Profile A
(**275*18(00|88|77|66|55|44)xxxxxxx|1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*#]@@.)
azrobert:
I hate dialing **n, so I removed all that code from my configuration. Therefore, I can't easily test the exact way you are dialing. I did successfully route a call out a SP trunk by dialing **275*18005551212.
Is SP1 your Phone Port Primary Line?
Do you want to route 800 numbers this way all the time? If yes, you can automatically add prefix "**275*" after dialing a 1-800 number.
Anyway, if SP1 is your Primary Line dial **275*18005551212.
If SP1 is not your Primary Line, add the following to the beginning of the Phone Port DigitMap:
(Msp1)|
Add above after the beginning paren.
Dial **275*18005551212
Dialing **1............. should work, so maybe something else is wrong.
Please post your Phone Port DigitMap
azrobert:
I forgot something if SP1 is not your Primary Line.
Add ,{(Msp1):sp1} to the Phone Port OutboundCallRoute.
It must be to the right of rule {(Mpli):pli}
Navigation
[0] Message Index
[#] Next page
[*] Previous page