800 calling through SipBroker (via CallCentric)
ianobi:
"[^*#]@@." is the original Obihai rule to allow for sip uri calling - "anything@anywhere.com"
"@@." allows any number of almost any alphanumeric characters. As pointed out earlier in this thread, it matches any digits as well as the intended use of sip uri addresses.
RonR suggested using "[^*#]@@.'@'@@." This rule needs a literal @ somewhere in the string before it will be matched, so now it can only match sip uri addresses and not digits that do not contain a "@".
I agree with azrobert, best advice is to drop any rules not being used.
Just tying up the loose ends here ... :)
mo832:
I got error messages on my phone when trying to dial 8xx numbers today using
proxy.ideasip.com
I went in and changed it to sip.tollfreegateway.com and 8xx numbers again went though.
1. Anyone else having the same problem with ideasip?
2. With both ideasip (for months) and now with tollfreegateway I am being told that it sends a random CallerID name/number. It is different every time, but it isn't mine and it isn't a standard number like the Google switchboard or a communications co. Anyone else notice this also? If so, which TF gateways are you SURE send the proper CID?
azrobert:
Here is my list of tollfree providers:
tf.arctele.com
tf.callwithus.com
sip.tollfreegateway.com
tollfree.alcazarnetworks.com
sip.denetron.com
sip.broker.com *1800...
sip.denetron.com
My previous testing showed they all passed CID correctly. Testing ideasip showed it did not pass callerid. I just tried one call with tollfreegateway and it worked. The userid used when defining the tollfree trunk will be used as the outbound callerid.
I was using Callwithus, but recently switched to Arctele. I made an 844 call that failed. Arctele and Sipbroker were the only providers that worked with the 844 number.
mo832:
Did ideasip work for you to complete the call? It failed for me multiple times today.
Where/ How do you set the outbound caller ID? And can you make it anything you want? Both name and number? I don't see anything that looks like it applies.
azrobert:
I just now tried a call with Ideasip and the call failed with error "407 Proxy Authentication Required". It looks like they now require you to setup an account.
The UserID for the trunk will be used as the outbound CallerID. For a SP trunk it's AuthUserName and for a VG it's AuthUserID. You can't set the name.
Navigation
[0] Message Index
[#] Next page
[*] Previous page