Obi 202
drgeoff:
Quote from: Redw00d on August 08, 2018, 03:37:12 pm
not yet, but
"6. Third line down, InboundCallRoute. Click as necessary on the two boxes at the end of that line until both are clear.
7. Replace whatever is in that entry box with
{ph,ob(123456789)}
using the 9 digit number of your OBi202 instead of the 123456789"
I have a RED explaination mark at the end of this line...??
Do not worry. That is normal. Just means it has been changed from the default value.
Redw00d:
ok, at this point, would you recommend, I delete ALL, re-set to 'factory standards' and then follow your advise?
I'm not getting the ring to both phones yet..
thank you
drgeoff:
Quote from: Redw00d on August 08, 2018, 03:55:05 pm
ok, at this point, would you recommend, I delete ALL, re-set to 'factory standards' and then follow your advise?
I'm not getting the ring to both phones yet..
thank you
Yes, if you have made previous changes from default such as disabling the Obitalk network.
But first do these checks:
1. From the 110's phone, dial **9 and the 9 digit OBi number of the 202.
2. From the 202's phone, dial **9 and the 9 digit number of the 110.
In each case the other phone should ring.
Redw00d:
"But first do these checks:
1. From the 110's phone, dial **9 and the 9 digit OBi number of the 202.
2. From the 202's phone, dial **9 and the 9 digit number of the 110.
In each case the other phone should ring.
BOTH gave me busy signals....
I might have things so balled up from trying so many things, I"ll start over, with only your stuff here... btw
drgeoff:
Quote from: Redw00d on August 08, 2018, 04:18:03 pm
"But first do these checks:
1. From the 110's phone, dial **9 and the 9 digit OBi number of the 202.
2. From the 202's phone, dial **9 and the 9 digit number of the 110.
In each case the other phone should ring.
BOTH gave me busy signals....
I might have things so balled up from trying so many things, I"ll start over, with only your stuff here... btw
Are you sure you dialled the number of the other OBi?
Did you dial as one long number eg **9123456789?
Are you sure it was a busy signal?
Navigation
[0] Message Index
[#] Next page
[*] Previous page