Obi202 Caller ID quit working on both lines. RESOLVED!
drgeoff:
Quote from: DaveFromRI on August 09, 2018, 01:38:55 pm
There is a setting: OBiExpert:Physical Interfaces:Phone 1/2:Calling Features:CallerIDEnable
I looked at that page on TWO different occasions and failed to see it. :-[
DaveFromRI:
Quote from: drgeoff on August 09, 2018, 02:28:41 pm
I looked at that page on TWO different occasions and failed to see it. :-[
Could that related to the newer firmware (5898)? To be honest, I'm not planning on upgrading just in case.
I didn't change the setting; it changed by itself. Moreover, I've had other problems with 5898, essentially it going MIA. It became a regular routine for me to power cycle it ever few days just to get it back (even started shopping for timers to do it for me).
gsmlnx:
Quote from: DaveFromRI on August 09, 2018, 03:19:34 pm
Quote from: drgeoff on August 09, 2018, 02:28:41 pm
I looked at that page on TWO different occasions and failed to see it. :-[
Could that related to the newer firmware (5898)?
No it is there on firmware 3.1.1 (Build: 5804)
drgeoff:
Quote from: gsmlnx on August 10, 2018, 08:03:19 am
Quote from: DaveFromRI on August 09, 2018, 03:19:34 pm
Quote from: drgeoff on August 09, 2018, 02:28:41 pm
I looked at that page on TWO different occasions and failed to see it. :-[
Could that related to the newer firmware (5898)?
No it is there on firmware 3.1.1 (Build: 5804)
Let me clarify that my failure to see it was nothing to do with the firmware version. I was actually looking on an OBi110 and the setting was indeed present but I didn't notice it. Possibly because I was thinking that if provided it would be in the same section as CallerIDMethod and concentrated my attention there.
Navigation
[0] Message Index
[*] Previous page