obi 200 red led
Nick0bi:
Hi,
I have obi200 that was working fine until a few days ago when I plugged it and it was solid red led. I have tried to reset the device using a paper clip and noting happens.
Is there a way to flash recover the device?
thank you so much
drgeoff:
https://www.obitalk.com/info/support/troubleshooting
Ensure that you are fully following the instructions for how to reset.
Nick0bi:
Thank you for the quick reply.
I have followed the instructions in the link you have provided and I have also tried a different 12v power adapter.
I have also created a support ticket but go no reply that is why I am trying this forum ;D
Any other tips would be greatly appreciated.
drgeoff:
Quote from: Nick0bi on August 14, 2018, 11:30:20 am
Thank you for the quick reply.
I have followed the instructions in the link you have provided and I have also tried a different 12v power adapter.
I have also created a support ticket but go no reply that is why I am trying this forum ;D
Any other tips would be greatly appreciated.
I fear it is effectively dead. Check your router's admin pages to see if the Obi is connected to it. In the very unlikely event that it is, try pointing a browser at the OBi's IP address and report back what happens.
The only other way to flash the unit might be via serial cable or JTAG but I don't know if the OBi implements those. Anyway if you had the equipment and knowledge to use those techniques they would have already occurred to you.
Nick0bi:
Correct there is no mac address showing the obi 200. I believe it's bricked :(
Anything else worth trying ?
Navigation
[0] Message Index
[#] Next page