Routing li1 Calls Between obi212 and obi202 Devices
dboling:
I purchased an obi212 and obi202. I haven't recieved them yet, waiting on amazon to deliver.
I plan on configuring sp1, sp2 and sp3(fax) as GV. sp4 will be callcentric 911,411. All outbound calls will use GV with the exception of 911 and 411. All GV inbound calls will travel through callcentric to use callerID service. This part of the config should be pretty easy.
The part of the setup I need help with is routing the LI terminal
I want the obi212 LI1 terminal to ring it's PH1 terminal and the obi202 PH1 terminal at the same time when receiving incoming call on the obi212 LI terminal. If the call is unanswered, I want it routed to google voice voicemail.
I figured this could be done using a voice gateway and obitalk PP, but I'm not sure how to do it.
azrobert:
It's a simple Line inbound route change. Send the call over the OBiTalk network to the OBi202.
Line InboundCallRoute: ph,pp(OBi202_OBi_Number)
This method requires a functioning OBiTalk network, it sometimes breaks. You could send the call directly over you local network to the OBi202, but you need to define a dummy trunk on each device.
You can make Line call from the OBi202 using the same method.
dboling:
Quote from: azrobert on August 27, 2018, 07:26:28 am
It's a simple Line inbound route change. Send the call over the OBiTalk network to the OBi202.
Line InboundCallRoute: ph,pp(OBi202_OBi_Number)
This method requires a functioning OBiTalk network, it sometimes breaks. You could send the call directly over you local network to the OBi202, but you need to define a dummy trunk on each device.
You can make Line call from the OBi202 using the same method.
As the 2 unit's will be running on the same network a dummy trunk sounds more reliable. Will this setup allow both units to ring at the same time and does it matter if the unit's are on different C classes ?
azrobert:
Both units will ring at the same time.
I'm assuming you're saying the units are setup as routers with different subnets. I don't own an OBi2x2, so I don't know what needs to be done. If the units were on real routers, you would need to setup a static route or port forward. Running the OBi's in Bridge mode would solve the problem. Maybe someone else will chime in.
dboling:
Quote from: azrobert on August 27, 2018, 08:23:42 am
Both units will ring at the same time.
I'm assuming you're saying the units are setup as routers with different subnets. I don't own an OBi2x2, so I don't know what needs to be done. If the units were on real routers, you would need to setup a static route or port forward. Running the OBi's in Bridge mode would solve the problem. Maybe someone else will chime in.
CentOS Linux server with several interfaces: eth0,eth1,eth2,ppp0,wlan0 all iterfaces are forwarding traffic between each other via iptables and all interfaces are assigned there own class C, except ppp0(DSL). I don't think it should be a problem connecting the devices.
Does the dummy trunk require a SIP as 3 GV and callcentric will use all 4 available SIPS ?
Navigation
[0] Message Index
[#] Next page