Inbound calls to PSTN number not working

(1/3) > >>

Ozzieken:
Still configuring my Obi110. I can call out ok, I can receive inbound calls on my DID number, but not with my PSTN number. I can receive ibnound PSTN calls with the Obi switched off, but not with it on.Could it be that there is a setting somewhere in a config file that has not been checked, or has been checked when it shouldn't be .... trouble is I don't know where to look. Can anyone point me in the right direction for this one please.

QBZappy:
See if you have this to make it ring the phone:

Setup Wizard->Inbound Settings->POTS-line InboundCallRoute = {ph}

RonR:
With no power applied to the OBi, the LINE Port jack is connected directly to the PHONE Port jack, which is why your phone rings in that situation.

Take a look at this page in the OBi:

Physical Interfaces -> LINE Port

Are all settings at Default (Default box checked)?

Is the OBi connected to a North American telephone service?

Ozzieken:
Quote from: QBZappy on September 09, 2011, 07:21:55 pm

See if you have this to make it ring the phone:

Setup Wizard->Inbound Settings->POTS-line InboundCallRoute = {ph}


Yes, these settings are ok.

Ozzieken:
Quote from: RonR on September 09, 2011, 07:22:36 pm

With no power applied to the OBi, the LINE Port jack is connected directly to the PHONE Port jack, which is why your phone rings in that situation.

Take a look at this page in the OBi:

Physical Interfaces -> LINE Port

Are all settings at Default (Default box checked)?

Is the OBi connected to a North American telephone service?



Line port has been set up for Australian conditions as per guidlines in this forum.

Navigation

[0] Message Index

[#] Next page