Inbound Call/DID Routing to SP1/2/3/4 Dial Tone

[technotite]

I now know that if you're using a line enabled OBi, you can use:

li('') to route all incoming calls to the PSTN dial tone.

Is there, by chance, a way to route inbound calls to SPx dial tone, without some sort of AA trickery?

[azrobert]

No, you can't get dial tone from an SIP provider.

You can modify the AA to only play the "Welcome" message, so it's not as annoying.

Voice Service -> AA Service
MenuTitle: &pause()
Menu: &pause()
PleaseWait: &pause()
EnterNumber: &pause()

After getting the Welcome message, dial 2 number #

You can record a dial tone and replace the Welcome message with this recording.
You can't change the 2 before or the # after the outbound number.