Obi 202 plus Cisco 7960 error 405

<< < (3/6) > >>

zapattack:
I believe the Proxy port in the phone must match the
Registrar Server Port in the OBi.
Also experiment with
X_SessionRefresh
X_DetectAlg
X_Sticky 18x
X_EarlyICEEnable    (to hear tones from far end)
X_EarlyICEEnableIn
A typical InboundCallRoute would be {>(1xx.):sp1}
if Using GV SIP on sp1 for free calls

chachi04:
Hmm. If I change the proxy to my my Registrar Sever Port (5060) I can't dial out.

My InboundCallRoute is {>(Msp2):sp2} because I'm using another GV number on SP1 to the phone interface. Is that the correct change if I'm using SP2 to the Cisco phone?

I'll try some of those other settings; thanks for the tips!

azrobert:
The IP Phone Proxy must match the SP Service X_UserAgentPort

chachi04:
Oh wow... phone scared me when it rang but, disabling X_Sticky 18x got an inbound call! I need to clean up some of my registration settings as I was messing with them but I'm closer!

cisco7960:
Making progress.... I've factory reset my Cisco 7960 and setup as follows:
Name: OBi200
Shortname: OBi200
Authentication name: OBi200
Authentication Password: OBi200PW
Display name: unprovisioned
Proxy address: 192.168.1.100
Proxy port: 5063

On the SIP settings at large:
Messages: URI
Preferred codec: g711ulaw
Out of Band DTMF: avt
Register with Proxy: YES
Register expires: 3600
TFTP Directory
Phone Label: Unprovisioned
Enable VAD: NO
VoIP Control Port 5060
Start media port 16384
End media port 32766
Backup port Unprovisioned
Backup Proxy port 5060
Emergency Proxy Unprovisioned
Emergeceny Proxy Port 5060
Outbound Proxy 127.0.0.1
Outbound Proxy Port 5063

I am getting inbound calls to the Cisco - but cannot make outbound.
Any ideas?
 line 1 on the device to use user name OBi200, pw OBi200PW, set the

Navigation

[0] Message Index

[#] Next page

[*] Previous page