Send calls from OBi200 to OBi202
N7AS:
Quote from: Taoman on October 23, 2018, 05:28:15 pm
Quote from: N7AS on October 23, 2018, 04:29:06 pm
I need CC to stay on my OBi200 as I receive calls from Voxbeam DIDs. I do not intend to connect a physical phone to the OBi202.
Do you receive incoming calls on your Localphone config? If not, you could easily make outbound calls via Localphone using a Voice Gateway freeing up an SP slot.
I already do that on my OBi1032 with a Voice Gateway. I mainly need a way to make outbound calls on that GV number.
Taoman:
Quote from: N7AS on October 23, 2018, 06:25:59 pm
I already do that on my OBi1032 with a Voice Gateway. I mainly need a way to make outbound calls on that GV number.
Understood. But you still didn't answer my question.
Do you receive inbound calls to your OBi200 SP1 Localphone configuration? Yes or no?
If yes, your best bet is probably azrobert's idea of moving your CC config to your 202 and route incoming calls to your 200 thereby freeing up an SP slot on your 200.
Routing calls from CC via SIP URI won't work for you since Callcentric strips out CNAM when using SIP URI.
PS. AFAIK, you can't use a Voice Gateway with Google Voice. For starters, when configuring the VG what would you use for AuthUserID and AuthPassword?
N7AS:
I use a Voice Gateway on my OBi1032 for Localphone. Localphone is a backup Prescott, AZ number in case my main number goes down (Future-Nime).
Taoman:
Quote from: N7AS on October 23, 2018, 09:31:08 pm
I use a Voice Gateway on my OBi1032 for Localphone. Localphone is a backup Prescott, AZ number in case my main number goes down (Future-Nime).
Since it's a backup number, you could forward it via SIP URI to your Callcentric account and free up that SP slot.
If the Localphone AZ number is a different one than the one on your 1032, make a Voice Gateway for it on your 200 for outgoing calls.
Just another option you could consider.
azrobert:
Using the OBiTalk network is the easiest way to route calls to the OBi202
OBi202
Voice Services -> OBiTalk Service -> InboundCallRoute:
{510222222>(xxxxxxxxxx):sp1},{ph}
Replace 510222222 with the OBi number of the OBi200
OBi200
Physical Interfaces -> Phone Port -> DigitMap
Add the following after the beginning parenthesis:
9xxxxxxxxxx|
Physical Interfaces -> Phone Port -> OutboundCallRoute:
The 1st rule is: {([1-9]x?*(Mpli)):pp}
Change it to: {(<9:510111111*>xxxxxxxxxx):pp}
Replace 510111111 with OBi number of the OBi202
Dial 94805551212 on the OBi200 and 4805551212 will be routed to SP1 on the OBi202
Navigation
[0] Message Index
[#] Next page
[*] Previous page