GV and Obi202 showing connected but no incoming or outgoing

(1/3) > >>

needshelp202:
I have my GV setup as the provider on the updated 202 (firmware).  The SP shows connected.  I have outgoing and incoming lines setup.  I get a dial tone on the attached phone.  When I dial the phone goes silent then some garbled static before I get a dial tone again.  I cannot call in to the phone.  It just rings and later goes to GV voicemail.

Any thoughts?  -Wags

drgeoff:
For incoming calls:

Log in to voice.google.com.  In the top left corner click on the 3 stacked horizontal lines.  Bottom left, click on "Legacy Google Voice". Top right corner click on the cogwheel and in the drop-down click 'Settings'. Select the 'Phones' tab.  Ensure that the line 'Obitalk device - nnnnnnnnn (where those 'n's are the 9 digit number on the bottom of your 202) is enabled.

needshelp202:
Thank you for the reply.  You are on the right track.  I followed the steps and under phone (legacy view) I just have our cell phone.  There is no Obi talk device.  I did link the device during the Obitalk setup but GV is not showing it.

needshelp202:
Is there a linking step that I missing to get the device to show in GV (legacy)?  On the ObiTalk config I signed into my Google account giving it permissions to Obi.

drgeoff:
Quote from: needshelp202 on November 06, 2018, 01:23:34 pm

Is there a linking step that I missing to get the device to show in GV (legacy)?  On the ObiTalk config I signed into my Google account giving it permissions to Obi.

Suggest you start again from scratch.

See SteveInWA's instructions at http://www.obitalk.com/forum/index.php?topic=13868.msg89076#msg89076.  Skip the stuff before "Since there are multiple factors involved, ..." and follow the bullet points.

Navigation

[0] Message Index

[#] Next page