GV and Obi202 showing connected but no incoming or outgoing
needshelp202:
Drgeoff,
Tried the bullet items from the previous post and no change.
I went into the settings (expert) and found the following firmware:
HardwareVersion 1.4
SoftwareVersion 3.2.1 (Build: 5794EX)
I see that my Obi device warranty expired last December and not sure if the Expert settings are all locked because of this. I cannot autoupdate firmware. Is the firmware the issue for the most recent GV change (looks like May 2018)?
How do I manually update the firmware and where is the best match?
SteveInWA:
You are doing something seriously wrong, but it's impossible to tell what it is, without looking over your shoulder. The fact that you a) have the old firmware that doesn't work with Google Voice, and b) you have no SIP entry on the Legacy Settings page means you didn't even start the procedure to link the two.
You DO understand that you need to add your OBi 202 to the OBiTALK web portal device page? You cannot use the local device's web page to do this. Go to https://www.obitalk.com/obinet/pg/obhdev. Is your device shown on that page?
needshelp202:
The only way I have accessed the device is through the obitalk web portal.
It shows up connected and green. I have reset this device by calling via the handset at least three times.
I have linked the device all three times by allowing Google Voice permissions from the portal setup. Managing Apps in Google shows the permissions allowed.
"Is your device shown on that page? " --YES, Green and Connected. I get a dial tone but no outgoing or incoming calls.
Seems to me that I need to get my firmware upgraded. How does one do this? It is not happening automagically and the damn expert settings is grayed out. What firmware should I have?
azrobert:
See:
http://www.obitalk.com/forum/index.php?topic=9983.msg95322#msg95322
Log directly into the OBi using the local interface.
Key the IP address of the OBi into a Web Browser and hit Enter
The UserID and default Password are both "admin".
Go to:
System Management -> Device Update
Under Firmware Update find the downloaded file and click Update
drgeoff:
Dial tone means nothing more than your phone is connected to a powered up OBi. You get dial tone from an unconfigured OBi straight out of the box. Even without being connected to your network.
Your opening post said "updated firmware". What prompted you to write that? The latest firmware versions are 5898 and 5921. One of those is usually pushed to the OBi soon after doing the **5 business to register on the portal. If the OBi is within the initial 1 year support period try dialling ***6 to check for automatic update. If one is not offered you can manually load firmware 5921.
1. Download it from http://fw.obihai.com/OBi202-3-2-2-5921EX-332148940.fw to your computer.
2. Dial ***1 and write down the IP address of your OBi which will be read out to you.
3. Enable access to the OBi's onboard interface from the INTERNET port. Dial ***0. Then dial 30#. The value 0 will be read out to you. Follow the spoken prompts to change that to a 1.
4. Point a browser at the IP address you wrote down. Login with admin and admin.
5. Click on the + to the immediate left of 'System Management'. Click on 'Device Update'.
6. Click on the "Choose file" box and navigate to where you saved the download.
7. Click on the "Update" box.
Navigation
[0] Message Index
[#] Next page
[*] Previous page