Adding "800" calls to Digit Map

<< < (2/2)

buster:
I was able to make the change via the website, and the call routing seems fine now.  Thanks!  However I do have another problem....

I call frequently into a conference system.  It's has both toll free and non-toll free access numbers.  When I call the toll free number (routing via my Comcast line - LINE port), if there's no audio on the other end (i.e. I'm talking) for over 1 minute, I get disconnected.  The same problem does not occur using GV.  Any suggestions? 

RonR:
buster,

Page 89/90 of the OBi Device Administration Guide describes the following OBi settings:

Physical Interfaces -> LINE Port -> DetectFarEndLongSilence
Physical Interfaces -> LINE Port -> SilenceDetectSensitivity
Physical Interfaces -> LINE Port -> SilenceTimeThreshold

which should be able to be adjusted to suit your needs.

ikishk:
I have a similar issue w/ certain call systems not answering via GV.  Its just a few numbers not a broad "all 800's."   How do I route specific numbers out LI and not SP1? (sorry to thread hijack, seemed very similar)

ikishk:
found it:

Physical Interfaces->PHONE->OutboundCallRoute

I prepended this:
{(1866xxxxxxxx|1888xxxxxxx):li},

tested and working :)

*x's here being actual numbers

Navigation

[0] Message Index

[*] Previous page