Group call as panic call
jamesatwork:
Greetings
I would like to have an OBI110 call several other OBI's as well as cell phones in case of emergency - something like a panic call.
Because the specific OBI110 is also used for regular OBI to OBI calling, I was wondering if its possible to link the (InboundCallRoute?) rule not to an OBI number, but rather to a speedial, so that the above 'group call' is activated only when, for example, *xx speedial is used
(I use GV for SP1/SP2)
Is this feasible?
Thanks!
azrobert:
The OBi110 can call up to 4 numbers simultaneously, but when the 1st person answers the other calls are terminated. How do you use GV on an OBi110?
jamesatwork:
Azrobert hi
My SP1 is GV - I just added this info to be complete
If my understanding is correct, the solution would involve programming an inboundcallroute on the receiving end of the call - something along the lines of call forwarding to several (Obi + non-Obi) destinations?
Thanks!
drgeoff:
Quote from: jamesatwork on November 19, 2018, 02:40:37 pm
My SP1 is GV - I just added this info to be complete
Google made changes to Google Voice many months ago. There is no firmware for OBi100 and Obi110 which now works with GV. They do continue to work fine with other ITSPs and Obitalk.
azrobert:
I just tested this by calling 2 extensions on a PBX. I added a rule to the beginning of the outbound route to call the 2 extensions. I dialed 0 and both extensions rang. I answered extension 200 which then terminated the call to extension 100. You can call up to 4 numbers. You will need to increase the MaxSessions on SP1. Your service provider on SP1 must support multiple simultaneous calls. I previously tested GV with 3 calls. I don't know if 4 will work.
Physical Interfaces -> Phone1 Port -> OutboundCallRoute:
{0:sp1(100),sp1(200)},
Physical Interfaces -> Phone1 Port -> DigitMap
Add the following after the beginning (
0|
Voice Services -> SP1 Service -> MaxSessions: 4
Speed dials will not work with this method.
If you don't want to use 0, just change the zeroes in the outbound route and digit map to whatever you want.
Navigation
[0] Message Index
[#] Next page