Trouble setting up 2 SPs
rvansmith:
I just go the OBi110, and I can setup SP1 with my google voice account without issues. I can also setup SP1 with Callcentric (I am going to use them as a 911 provider) using the OBi ITSP setup utility. But I can not get both to work together as SP1 and SP2. I am confident that I can get Google Voice to work, I have done it many times on SP1. But as soon as I move it to SP2 I get Register Failed: 403 error in the System Status page. If I have google voice setup on SP1 and try and setup Callcentric on SP2 I get a Connection Failed: Authentication error. Note, these are the same login settings that work on SP1. I have Build 1890 on my device, and I use AT&T U-Verse as my ISP with their gateway.
Failing manually setting it up, I tried the OBiTalk.com gateway, and when I try to add a new device it gives me the **5 XXXX number to dial, and the automated voice tells me it sent the number, but nothing happens on the OBiTalk.com webpage.
Any help would be appreciated.
SIPit:
I had the same problem when I tried to add my OBi110 to the portal with IE. Firefox worked fine.
QBZappy:
Just something to check. Make sure you use SIP as the signaling protocol in the following setting:
Service Providers->SignalingProtocol->ITSP Profile B->General
Since you have been playing around with your setting it might have been overlooked.
Since you are getting "403 Authentication User Name does not match account name" it sounds like your credentials to register to the service might be the problem. I'm sure you double checked that.
MichiganTelephone:
If you can get SP1 to work with a particular provider, but not SP2 even when you use the exact same settings, then I'd check to see if any default settings are different — for example, by default X_UserAgentPort is set to port 5060 for SP1 and 5061 for SP2, but if you are using SP1 and SP2 with different providers then there's no reason that the SP2 port can't also be 5060 (it only has to be different if both SP's go to the same provider and switch). Changing that setting in SP2 might fix your problem, assuming you haven't tried that already.
rvansmith:
I tried Firefox and that did not let me add my device to the ObiTalk.com. Same thing, it just times out, the **5xxxx tells me it sent the number to the server but the count down just goes to 0. I also verified the second service provider was set to SIP. And I did my best to make sure all settings between the two were the same. Still can't get SP2 to connect.
Navigation
[0] Message Index
[#] Next page