Hi all,
I purchased an Obi202 some time ago, stopped using it when they dropped GV support, and just tried to get it up an running again. After updating the firmware in my Obi202 and in my router (TP-Link Archer C9 v1), I can make and receive calls, but I don't hear anything through my phone's speaker (Vtech cordless phone). The phone that I call can here what I'm saying, but I can't hear them. I also don't hear the phone ringing when I place a call. Finally, I can't hear any audio when I try to do an echo test. (**9 222 222 222). Any help you can provide would be appreciated.
Steps I've taken so far:
1. Did a factory reset of my Obi202. Installed the newest firmware. HardwareVersion: 1.4, SoftwareVersion: 3.2.2 (Build: 5921EX)
2. Installed new firmware on my router (TP-Link Archer C9 v1.0, Firmware Version: 3.17.1 Build 20180125 Rel.56387n
)
3. Re-setup Google Voice through my Obitalk Dashboard.
4. In Google Voice, made sure that my calls were forwarded to my Obi device, not Talk/Chat or another phone.
5. Made sure the correct ports were open on my router as specified here, and set a fixed IP address for my Obi device:
https://www.obitalk.com/info/faq/Troubleshooting-sec/ports-to-keep-open-on-my-router6. Checked for a SIP ALG setting for my router, but it does not appear to have one.
Here is the Call Status when I make a call with my Obi202:
Number of Active Calls: 1
Call 1
Terminal 1 Terminal 2
Terminal ID PHONE1 SP1
State connected connected
Peer Name
Peer Number XXXXXXXX XXXXXXXX
Start Time 12:40:18 12:40:18
Duration 00:00:06 00:00:06
Direction Outbound Outbound
Peer RTP Address 74.125.39.50:19305
Local RTP Address 192.168.0.125:16600
RTP Transport UDP
Audio Codec tx=G711U; rx=G711U
RTP Packetization (ms) tx=20; rx=20
RTP Packet Count tx=1064; rx=1058
RTP Byte Count tx=183008; rx=181976
Peer Clock Differential Rate 0 PPM
Packets In Jitter Buffer 5
Packets Out-Of-Order 0
Packets (10ms) Interpolated 1
Packets Late (Dropped) 0
Packets Lost 0
Packet Loss Rate 0 %
Packet Drop Rate 0 %
Jitter Buffer Length 100 ms
Received Interarrival Jitter 2 ms
DTMF Digits Received 0
Jitter Buffer Underruns 0
Jitter Buffer Overruns 0
Sequence number discontinuities 0
skew compensation 0 ms
send silence 0
MOS 4.40
Thanks for any help or suggestions you can provide. I appreciate it.
Best regards,
Joe