Obihai 200 power light blinking green
keraba:
I've had an Obihai 200 for several years, and recently, the power light is just blinking green. There's no dial tone.
I've power cycled both it and the router. No change.
Ideas?
Sheffield_Steve:
"If your OBi device is connected via the ethernet cable and the power LED is blinking GREEN, that indicates that the OBi device cannot get an IP address from your router. In other words, the OBi device cannot connect to the internet."
i.e. You have a network problem. Router, etc.
Self-Troubleshooting Guide
drgeoff:
A network problem should not also cause no dial tone. Looks like the OBi200 is faulty.
Try a hardware reset.
keraba:
Thanks for the feedback and confirmation.
I've tried this a couple ways, without any change. Maybe I'm doing it wrong. I tried pressing the reset button with a paperclip; it didn't do anything. Then I held it down while powering it on; it just went through the same light sequence during power up.
So maybe a factory reset isn't working either, unless someone can suggest something different?
drgeoff:
https://www.obitalk.com/info/faq/Troubleshooting-sec/How-to-Factory-Reset
Navigation
[0] Message Index
[#] Next page