The number you dialed has not received a response from the service provider
zapattack:
This option change killed my 200!
.............................................
I now only have an occasional red flash from the power light, nothing else.
Will have to find most recent backup and hope I can remember config changes since then.
SteveInWA:
Whuuuuuuut??? Did you enter that option on an otherwise working device, and it bricked?
zapattack:
About two years of service on unit.
Many reboots over its life due to changes in SPs and dial plan with no problem.
Red light flashed after this reboot, then nothing for a long time,
then only an occasional flash.
Pushed reset while powered on, no change in flash.
Held reset while powering on, same occasional red flash.
But my 110 is till running fine....
SteveInWA:
So, just a coincidence, unrelated to the 27 setting.
Did you try using the power supply from the 110 to run the 200? They are interchangeable. If it still fails, then it's hammer time.
zapattack:
110 supply has lower rating.
Would not even power red flashes.
Moving on.....
Navigation
[0] Message Index
[*] Previous page