News:

On Tuesday September 6th the forum will be down for maintenance from 9:30 PM to 11:59 PM PDT

Main Menu

Trouble configuring an old obitalk device on current google voice acct.

Started by Steevo1, February 18, 2020, 10:27:35 PM

Previous topic - Next topic

Steevo1

I have two Obi 200 devices connected to google voice. Working OK.
I have an old Obi 100 that I pulled out and updated the fw to
SoftwareVersion   1.3.0 (Build: 2886)m the latest.
That is supposed to support the current google voice Oauth scheme.

I configured the unit on the same acct as the two Obi 200s and the same google voice account.
It all looks ok.

The google login popup appeared and I clicked the correct acct.
The only discrepancy I noticed during the process is that the google terms and conditions pane loaded blank, but I clicked accept anyway.

The Obi 100 has an IP and seems to be working on the network, I am looking at the devices UI.

Service Providers Name Status Settings
SP1 Google Voice

Backing Off :
TCP connection to 173.194.203.125 failed

This is supposed to be working, I think many old Obi 100s are still working.
What could be wrong?
Can anyone suggest steps to find the problem?

drgeoff

OBi1x0 devices have not supported GV since about 2 years ago. There will be no firmware upgrade to change that.

Depending on what you want to achieve a workaround may be to route calls to anď/or from the OBi100 via a GV account on one of your OBi200s.

Steevo1

These obitalk devices are all working on the same GV number and account. Just ringing at different locations.
How would I do that? Route through an Obi 200?
Thanks

azrobert

The below assumes GV is defined on OBi200 SP1.
Use OBi Expert to make the following changes:

OBi200

Voice Services -> SP1 Service -> MaxSessions: 4
Voice Services -> SP1 Service -> X_InboundCallRoute:
ph,pp(200222222)

Voice Services -> OBiTalk Service -> InboundCallRoute:
{200222222>(Msp1):sp1},{ph}

Replace 200222222 with the OBi number of the OBi100

OBi100

Physical Interfaces -> Phone Port -> PrimaryLine: SP1 Service
Physical Interfaces -> Phone Port -> OutboundCallRoute
The 1st rule is: {([1-9]x?*(Mpli)):pp}
Change it to: {(<510111111*>xx.):pp}

Voice Services -> OBiTalk Service -> InboundCallRoute: ph

Replace 510111111 with OBi number of the OBi200

Any number dialed on the OBi100 will be routed to GV on the OBi200 SP1
Inbound GV calls will be routed to the phone ports on the OBi200 and OBi100

Steevo1

Thanks! 
Will that busy out the OB200?  Oh, I guess with on GV number it doesn't matter.
Thanks for all your help. That was great.