New FW 3.2.2 build 5921EX breaks Bluetooth???

(1/1)

msnews:
I have BT dongle on my Obi200 and it works fine running firmware 3.2.1.5757EX for 6 months. Today I changed Autoupdate firmware to enable and the system automatically updated to 3.2.2-5921EX. Now I have issue to dial if I set phone primary line to Bluetooth. No dial tone, and then the system reboots itself. I am unable to roll back the previous working version because it always says the firmware package has checksum error when I use Device Update to load the original firmware.

I wish they can push a fix very soon but meantime I need some help to roll back the firmware.

Any advice? Thanks

azrobert:
This bug was previously reported. Set the Primary Line to SP1 then make the following changes with OBi Expert.

Physical Interfaces -> Phone1 Port -> DigitMap
The last rule is (Mpli)
Change it to (Mbt)

Physical Interfaces -> Phone1 Port -> OutboundCallRoute
The last rule is {(Mpli):pli}
Change it to {(Mbt):bt}

The above will disable the Primary Line and force calls to BT.

or

Set the Primary Line to SP1 then use **8 prefix when dialing a number.

Edit:

Polycom made firmware changes that cause the checksum error on older firmware. I don't know when the bug was introduced or what firmware versions will load. You can try the following firmware.

http://fw.obihai.com/OBi202-3-2-2-5859EX-198839.fw

msnews:
thank you, I can roll back to the firmware you recommended and all work fine.

I have another question, I want to have the following scenario to work:

1. If the first 3 number I dial is 011 which means I am dialing international call, I want OBI200 to use SP1 automatically.
2. all other calls will use BT1 automatically i.e. through my local cellphone.

How to configure it?

Navigation

[0] Message Index