Obi212 issue with Line to Sip
Weyan:
Can't seem to get this working right, want any calls to Line1 to goto Sip provider and call a specific number. Have configured Line port as follows:
Inboundcallroute: sp
CallForwardUnconditionalEnable yes
CallForwardUnconditionalNumber sp1(0203432xxxx)
This results in:
Call Ended (403 Username in From Field required)
Calls from the phone line work fine. I have also tried using Sp2, and that can bypass the 403 problem but the calls also don't work as the call hangs there with 0.0.0.0:0 RTP address, instead of the Sip IP that appears when I use the phone. Just registered device with OBiTALK which has given it latest firmware at least. The Sip provider is sipgate.co.uk.
drgeoff:
Putting sp into any InboundCallRoute does not make sense.
Try putting sp1(0203432xxxx) in the LINE port InboundCallRoute and reverting both the CallForward... fields to default (ie not enabled).
Weyan:
Ah, ok misunderstood how that worked. Made the change. It has same result though.
drgeoff:
Can you call OK over the Sipgate SP1? Ie if you dial **1 0203432xxxx does the call succeed?
Weyan:
I can call using the physical phone plugged into phone port. I am trying to use Sp2 again now as the phone port always reverts to Sp1, but after I try making a call the settings all disappear as if the error resets it.
Navigation
[0] Message Index
[#] Next page