Obi212 issue with Line to Sip
Weyan:
Ok it seems Obitalk config kept overiding the settings. I deleted Sp1 as Sp2 wouldn't register as well. And now I get:
Call Ended (404 Not found (no match)).
drgeoff:
Sounds like you are altering settings by logging in to the OBi's local IP address. If you have not disabled Obitalk provisioning any changes you make will sooner or later overwritten by those on the portal. An alternative is to enter Expert mode from your dashboard at obitalk.com and make all your changes there. You need to clear both boxes at the right hand end of a line before you can make a change.
Weyan:
I got it working, seems I was trying to make it too complicated by altering a lot of settings local first. Reset everything using Obitalk, registered Sp1 and just added the one forward, now the redial works. Only two other issues:
Want to get intercom redirected, as in a local intercom signal is sent and that is rerouted as a call would be. And there is quite a bit of delay before the call is rerouted, I think I remember seeing some settings that control that as well.
EDIT:
All working great now. Set RingThreshold to lowest and have reduced RingDelay to 0 as callerid won't be necessary for this line. Thanks for the help.
Navigation
[0] Message Index
[*] Previous page