Use obi 110 to place landline calls

(1/3) > >>

Msanad:
Hi,
I was searching the last week for such solution to be able to use my landline to place call using mobile app while i'm outside home , and found that obi110 device that can do this feature if i can understand well.

the question now , does it possible to do this? i.e to connect my landline to obi 110 and plug the network cable to it , then i can be able to use my landline to place/receive phone calls through mobile app ?

can i know the procedure.

thanks.

azrobert:
You need an SIP service provider. Get a free Callcentric IP Freedom account here:
https://www.callcentric.com/rate/plans/ip_freedom/

Log into your account
Click Extensions
Click Add New Extension
Select Extension 101
Enter Password
Confirm Password
Select CallerID (There should only be one)
Click Apply

Your account number is 1777xxxxxxx
The main account defaults to extension 100
Extension 101 account number is 1777xxxxxxx101

On your mobile install the free Zoiper softphone app
On the Account Setup screen tap Providers List
Tap Next
Select Callcentric
Tap Get Configuration
Username: 1777xxxxxxx101
Password
OK

On your Callcentric account dashboard click Extensions
Extension 1777xxxxxxx101 should show "Your phone is registered"

When you get this far, post back and I'll show you how to configure your OBi110.

Do you have any service providers defined on the OBi110?
Is the OBi110 added to the OBiTalk portal?
The OBi110 doesn't have to be added to the portal.

Msanad:
Hi azrobert,
thanks for your reply , i will follow your above instruction and feedback.

Msanad:
Hi azrobert

Now i have my phone registered into Callcentric , can you tell me the next

btw : i dont have any configuration into OBi101 , its new device and never touched and not even register into  OBiTalk portal.

waiting for you
thanks

azrobert:
You don't need to register your OBi110 to OBiTalk and I recommend that you don't.

Connect the OBi110 to your router, connect the Line port to your landline and connect a phone to the Phone port. Make sure everything is connected correctly by placing a call from the phone connected to the OBi110. Does it work?

You need to know the IP address of the OBi110. Dial ***1 from the phone attached to the OBi110 and it will say the IP address.

Key the IP address into a browser and press Enter.
The OBi110 username and password are both admin
To make a configuration change, the box to the right of the value must be unchecked.

Service Providers -> ITSP Profile A -> SIP
Click Service Providers on the left column then ITSP Profile A then SIP
Make the following config changes:
ProxyServer: callcentric.com
RegistrationPeriod: 1800

Click Submit at the bottom of the page.

Voice Services -> SP1 Service
X_InboundCallRoute: {>1777xxxxxxx:aa}
AuthUserName: 1777xxxxxxx
AuthPassword: your_callcentric_pw

Replace 1777xxxxxxx with your Callcentric account number
Submit
Click Reboot on the top right.

Wait for the OBi110 to reboot.
Status -> System Status
Scroll down to SP1
It should show Registered

Dial 100 from your mobile app
You should get connected to the OBi110's Auto Attendant
After the Prompt, enter 2 for make a new call
After the 2nd prompt enter a number followed by a #
Does it work?

Navigation

[0] Message Index

[#] Next page