Use obi 110 to place landline calls

<< < (2/3) > >>

Msanad:
Hi azrobert.

Thanks for the support.

I can now use app to dial 100 and i got the AA prompet , then i dial 2 to be able to perform landline call , the issue is the place i live now has only phone line with no subscription ( used only for ADSL connection ) , thus i think  i got a tone which mean unable to reach the number after dial with # , i'm plan to move home in June , where i can place the device attached to the PSTN line.

i have couple of questions:
what is the need for 101 extention i create before into callcentric ?
do i still can use the phone attached directly to Obi101 to place direct call to landline , which code i have to use or what is the procedure.
what about caller ID , does it work normally ?

Thanks again for your support.

BR

azrobert:
The Callcentric main account defaults to extension 100, so when you register the OBi110, it becomes extension 100. To call the OBi110/extn100 you must register your mobile as a different extension (101).

You can use the phone attached to the OBi110 to make or receive landline calls. The default is to send outbound calls to PSTN, so no need for a code. You can make outbound calls more efficient by modifying the Phone DigitMap. Just tell me the format (7, 10, 11 digits, international) of the numbers you need to call and I'll show you how.

If your PSTN service provider supplies CallerID then you will see it on the phone attached to the OBi110.

Msanad:
Hi azrobert.

usually , the my home landline is for local and long distance calls , area codes are two or three digits depend on the destination + 7 digits .

local calls in same town will use 8 digits
long distance call with use ( area code 2 or 3 digits + 7 digits)

thanks

azrobert:
Use the following when ONLY calling 8, 9 or 10 digits. 8 and 9 digits will have a 2 second delay, 10 digits zero delay. Everything else will fail.
Physical Interfaces -> Line Port -> DigitMap:
(xxxxxxxx|xxxxxxxxx|xxxxxxxxxx)

Use this for calling other numbers. 8, 9 and 10 digits will have a 2 second delay, everything else a 3 second delay.
(xxxxxxxx|xxxxxxxxx|xxxxxxxxxx|xx.S3)

This is the default. 7 digits a 4 second delay and 11 digits 2 second delay. Everything else a 10 second delay
(xxxxxxxS4|1xxxxxxxxxx|xx.)

The Line Port default settings are for North America. If you have problems, I can't help. Create another topic and maybe someone else will help.

Msanad:
i will configure the below one reach home so i can test with my home landline .

meanwhile i wonder if i can receive landline calls directly to my mobile app or some configuration required.

thanks again for your support.

Navigation

[0] Message Index

[#] Next page

[*] Previous page