Caller ID block and spoofing...

<< < (2/2)

SteveInWA:
The speed of your reply suggests that you didn't read my post for comprehension.  I already explained this.

You set this up on the OBiTALK web portal.  You can change it there.

jbuszkie:
I guess you didn't read my OP.

I know how to setup a SP to make the outgoing calls.

What I don't remember is how/why phone power shows my GV number.

My outgoing call are routed through phone power.  When I enable the caller ID with *82 the calls shows up with my GV number... Not the phone power number. (which is what I want)
I'm trying to figure out how I set that up!  Was it with Phone power or some expert setting with my OBi

Jim

SteveInWA:
Come on.  Look at the screenshot I posted.  Go to your OBiTALK dashboard.  Click on your OBi device.  Click on each SP1--SP4 and look for the presence or absence of the check-mark.

jbuszkie:
Quote from: SteveInWA on May 24, 2019, 12:58:18 pm

Come on.  Look at the screenshot I posted.  Go to your OBiTALK dashboard.  Click on your OBi device.  Click on each SP1--SP4 and look for the presence or absence of the check-mark.


I have no issue setting a SP for primary outgoing calls.
My primary outgoing SP (phonepower) is not showing my Phonepower number on callerid.  It's showing a different number.  How did I get phone power to show a different number?

SteveInWA:
See:  http://bfy.tw/Nokr

Navigation

[0] Message Index

[*] Previous page