SETUP OBI202
TomTTT:
Sorry for the confusion, I setup Google Voice 1 to SP1 and Google Voice 2 to SP2 on the OBI202. So, I am assuming phone port 1 will ring GV 1, and phone port 2 will ring GV 2.
Instead, phone port 1 rings GV 1, but phone port 2 has no dial tone.
The strange thing is that when I connect a NEW un-configured OBI200 to the network, and I connect the phone to the phone jack of the NEW OBI200, it is ringing GV 2.
Do I need to factory reset everything? I want to avoid resetting my OBI202 and somehow, get the dial tone back.
SteveInWA:
You probably have a bad telephone cord plugged into the Phone 2 jack. Replace it with a different two-conductor modular phone cord with two-pin jacks on each end. While the cord is unplugged on each end, inspect the jacks in the OBi and in the telephone, to make sure none of the gold pins are bent.
drgeoff:
Quote from: TomTTT on June 13, 2019, 04:48:34 pm
Sorry for the confusion, I setup Google Voice 1 to SP1 and Google Voice 2 to SP2 on the OBI202. So, I am assuming phone port 1 will ring GV 1, and phone port 2 will ring GV 2.
Instead, phone port 1 rings GV 1, but phone port 2 has no dial tone.
Your assumption is incorrect. There is no hard mapping of SP1 to PHONE1 and SP2 to PHONE2. Each phone port can use any one of SP1-4 to make a call. Calls coming in on any of SP1-4 can ring either PHONE1 or PHONE2 or both.
As I wrote above the PHONE ports should always give dial tone no matter how SP1-4 are configured. Try swapping over the phones and cords that you have plugged in to PHONE1 and PHONE2 sockets. Does the lack of dial tone move to PHONE1?
Navigation
[0] Message Index
[*] Previous page