obihai 200 no audio on incoming call anveo

<< < (2/2)

drgeoff:
Dial the echo test number **9 222 222 222.  If you hear "Welcome to Obitalk and ...." there is no hardware fault with your OBi200 or your phone.

jaspshah1:
hi Guys, thanks for your advice. echo test is fine. GV works fine so it seems that phone hand set is fine. as re status- phone port, there are values. Outgoing on anveo is clear. Incoming and outgoing on GV is also clear. if any other advice, pls share/post your views.

SteveInWA:
Despite your assertion that you've had your hardware for years, without changing it, this sounds like a router issue to me.  Unless you knew what you were doing, you may have chained the two routers together, creating a double NAT setup.  You either need to configure the TG to run in bridge mode, or move the OBi's Ethernet connection to the TG, not the Netgear.

As Taoman already pointed out, the definitive way to prove or disprove this is to temporarily take the OBi and telephone to some other location's network and see if the symptom changes.

Navigation

[0] Message Index

[*] Previous page