I can't make the pbxExtension Application work with Obi110's
RonR:
The Home phone OBi nneds to have the following Default setting:
Voice Services -> OBiTALK Service -> InboundCallRoute : ph
You were supposed to start both OBi's at factory defaults, but if you didn't disable Auto Provisioning before they had access to the Internet and rebooted, the OBiTALK Web Portal could have overwritten a bunch of your settings.
I would recommend you check all pages in both OBi's and make sure everything is at Default except the the changes I outlined.
acsscott:
RonR,
Is Physical Interfaces -> LINE Port -> RingDelay that amount of time in msec that the Obi110 at the office waits before answering(off hook) the ring on the LINE connector?
If so, I believe I could increase this to more than 4000, to give the office time to answer the phone before it forwards it to the Home Obi110.
RonR:
No. Leave RingDelay alone. It doesn't do what you're thinking.
Your problem should be in the Home phone OBi OBiTALK Service InboundCallRoute being set to aa instead of ph.
acsscott:
aa makes the Obi Attendent come up asking 1, 2, 3. I just want it to go through after like six rings.
RonR:
In OBi #1 (Home), set:
Voice Services -> OBiTALK Service -> InboundCallRoute : ph
It should already be there if you started the OBi out at factory defaults. That causes all calls coming in from the OBiTALK Service (which is what we're using to relay the call) to go to the PHONE Port.
Since incoming calls are going to the Auto Attendant, it probably got set to something containing an aa rule by the OBiTALK Web Portal before you got Auto Provisioning disabled.
Navigation
[0] Message Index
[#] Next page
[*] Previous page