I can't make the pbxExtension Application work with Obi110's
acsscott:
RonR,
Sorry. Yes the ATA on our pbx has a cordless phone and the Obi110 on it.
More info:
I just called the office. Both the Phone & Line LED's on the office obi110 were flashing when it was ringing, but the Home Obi110 never flashed the LED's, or made the phone attached to it ring.
RonR:
I don't know how or where an ATA at the office comes into this picture. If you're wanting to remote a PBX extension to your home using two OBi's, you'd connect the PBX extension port (FXS) to the LINE Port (FXO) of the office OBi.
Start both OBi's at factory defaults and configure them as follows:
OBi #1 (Home):
Physical Interfaces -> PHONE Port -> DigitMap:
([1-9]x?*(Mpli)|[1-9]|[1-9][0-9]|911|**0|***|#|**1(Msp1)|**2(Msp2)|**8(Mli)|**9(Mpp)|<2*>xx.)
Physical Interfaces -> PHONE Port -> OutboundCallRoute:
{([1-9]x?*@@.):pp},{(<#:>|911):li},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},
{(<**2:>(Msp2)):sp2},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli}
User Settings -> Speed Dials -> 2 : PP(ob200123456)
where 200123456 is the OBiTALK Number of OBi #2.
OBi #2 (Office):
Voice Services -> OBiTALK Service -> InboundCallRoute: {200654321>(xx.):li},{200654321:aa},{ph}
Physical Interfaces -> LINE Port -> InboundCallRoute : {pp(ob200654321)}
where 200654321 is the OBiTALK Number of OBi #1.
Calls placed on the Home phone (OBi #1 PHONE Port) should dial through the Office PBX extension (OBi #2 LINE Port).
Calls to the Office PBX extension (OBi #2 LINE Port) should ring the Home phone (OBi #1 PHONE Port).
OBi Device Administration Guide
acsscott:
Thanks for all the help.
Ok, I can get everything entered but:
Physical Interfaces -> LINE Port -> InboundCallRoute : {pp(ob200654321)}
I put this in with my units #. Hit submit, hit reboot. It reboots, my number is there, then it resets again, and it is back to "ph"
RonR:
If you're configuring the OBi's directly (as opposed to through the OBiTALK Web Portal), you must disable Auto Provisioning in the OBi's or the OBiTALK Web Portal will keep reconfiguring them to all of its settings:
System Management -> Auto Provisioning -> ITSP Auto Provisioning -> Method : Disabled
acsscott:
Thank you for all your time. We are getting very close.
I can call out from the home to the office no problem. It grabs the pbx, and I can dial out.
When the office line is ringing, after about 4 rings, it answers and gives the obi attendent -> 1 to continue the call, 2, 3. How do I make it do #1 automatically, so it just go's through and rings the phone connected to the phone connector at home.
Thanks again for all your help.
Scott
Navigation
[0] Message Index
[#] Next page
[*] Previous page