Obi202 Call Routing

(1/3) > >>

VladimirM:
Hi,

I am trying to set up Obi202 to route calls from SP4 to SP1, SP2, and SP3 based on prefix. I am testing on SP4 to SP1 routing

I believe I have tried all possible combinations in SP1 DigitMap and SP4 X_InboundCallRoute with no success so far.

First, I set X_InboundCallRoute to "{(Msp1):sp1}" and played with the DigiMap:
(!911|<991:>*xx|<991:+>1xxxxxxxxxx|<991:+1>[2-9]xxxxxxxxx|<991011:+>xx.)

I tried replacing "991" with "**9", "9**", etc. with no luck.

Then I changed DigiMap to:
(!911|*xx|<+>1xxxxxxxxxx|<+1>[2-9]xxxxxxxxx|<011:+>xx.)

For the X_InboundCallRoute I tried
{(<991:>xx.):sp1}
{(<991:>@@.):sp1}
{(<991:>(Msp1)):sp1}

Still no fun.

What am I doing wrong?

Thank you,
Vladimir

azrobert:
I don't understand what you are trying to do.

Service providers are defined on SP's. Phones are connected to Phone ports. Outbound calls are routed from a Phone Port to an SP. These calls can be routed to different SP's based on the number dialed.   Inbound calls are routed from an SP to a Phone Port. These calls can be routed to Phone1 or Phone2 based on CallerID.

Inbound calls can be routed to another SP based on CallerID, but an outbound number must be supplied. For example, you can route an inbound call to your cell phone using a service provider defined on a different SP, but you need to include your cell number.

Please explain exactly what you are trying to do.

azrobert:
I read your post again and it looks like on outbound calls you want to remove "991" prefix and replace it with "+". Is this correct? Do you want to route these calls to SP1 or a different SP? How many service providers do you use?

Outbound routing is defined here:
Physical Interfaces -> Phone1/2 Port -> OutboundCallRoute

X_InboundCallRoute is used for routing inbound calls for that SP.

drgeoff:
My interpretation of the opening post is that he is trying to configure a call-through facility.  External call comes in on SP4.  Caller then touch tone dials a prefix (eg 991, 992 or 993) followed by a phone number.  Obi then forwards the call to that number using SP1, SP2 or SP3 depending on the prefix.

VladimirM:
Hi DRGeoff,

Your understanding is exactly correct.

I need to be able to route a call coming on SP4 to other three (3) SPs based on a prefix dialed. Phone ports (PHx) are not being used.

Thank you,
Vladimir

Navigation

[0] Message Index

[#] Next page