Need Help Where To Download A Previous Obi200 Firmware Update

<< < (2/2)

azrobert:
Quote from: graybeard47 on September 15, 2019, 07:57:13 am

I realize that the update is a far reach, but I have nothing to loose before "paying" for support, again that is not very timely to get things up and running


Don't waste your time and money, just buy a new OBi200.

graybeard47:
"Don't waste your time and money, just buy a new OBi200."

The above quote from azrobert on this subject really came calling after manually installing the new firmware and doing a factory reset that did nothing for this Obi200 to be actually functional.

So my question, is my unit that is closely approaching 4 years old already deficient  in enough ways as a newer unit is more user and technically more friendly for basic use?

And if a newer unit is purchased, is the setup just plug and use from my hell experienced on m first round around 4 years ago?

Thanks

drgeoff:
A new OBi200 will give you the same configuration and use experience that your current one did.

SteveInWA:
You may or may not have a hardware problem.  You started your discussion by jumping to an assumed solution, rather than diagnosing the problem.

Here is the guideline: if your device fails these tests, then it has a non-repairable hardware failure, and it is time to buy a new one:

Perform the "restore to factory defaults" procedure, using the paper-clip method (if you need more details, ask).Plug a standard touch tone telephone's cord into the phone jack on the OBi.  Do not attach it to any premises wiring.Pick up the phone.  Do you hear a dial tone?  If not, try a different telephone and cord.  If you hear a dial tone, then the device is likely OK.  If you don't, and the device will not respond to pressing ***1, then it is dead.  Buy a new one.
What happens?

Navigation

[0] Message Index

[*] Previous page