Service Provider Selection for Outbound Calls
azrobert:
I'm also getting errors sending a PM, so here is my reply.
There was a bug causing no dial tone when setting the Primary Line to TG1. I assumed it was fixed, but maybe I'm wrong. Make sure you're at the current fw.
Download here:
http://fw.obihai.com/OBi202-3-2-2-5921EX-332148940.fw
Anyway, the fix is to change the Primary Line back to SP1 and then override it with code.
The last rule in the Phone DigitMap is "(Mpli)" change it to "(Mtg1)"
The last rule in the Phone OutboundCallRoute is "{(Mpli):pli}" change it to "{(Mtg1):tg1}"
KevKan:
Thanks azrobert.
System Status showed my firmware to be 3.2.2 (Build: 5921EX) without the 332148940.fw suffix. I downloaded this version and when I attempted to install it , I received the following message "Previous version identical to the update. Firmware not modified"
After making the changes you suggested, I now get a Dial Tone when I go off hook. After dialing a local 7 digit number, there is an 8 second pause followed by the reorder tone/fast busy signal. This is true of both Line 1 and 2.
I assumed you wanted me to make the changes you suggested to both ports.
I am ready for more suggestions.
azrobert:
Service Providers -> ITSP Profile A General -> DigitMap:
(<1aaa>xxxxxxx|1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.S3)
Service Providers -> ITSP Profile B General -> DigitMap:
(911|<1aaa>xxxxxxx|1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.S3)
Service Providers -> ITSP Profile C General -> DigitMap:
(<1aaa>xxxxxxx|1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.S3)
Replace aaa with your local area code.
KevKan:
After making these changes, when I go off hook on either Line 1 or 2, I now fail to get a dial tone and receive the "ToneOnPrimarySeviceDown" which I have set to SIT1.
TODAY, 10/02/19, without making any changes it appears to work!!
Hopefully I haven't accidentally tarnished your stellar reputation as the "Master" of the Obi Hai language here on the forum with my problem. I also hope I haven't caused you to pull all of your hair out!!
I suspect the problem last night was possibly due to the fact I had lost registration with ITSP "A". They only allow 4 devices to be simultaneously registered and I believe it re-registers each time you submit a change. After four registrations you are locked out until one of the previous registrations expires which is about an hour.
I am puzzled why the call didn't go to SP 2, Google Voice, last night but it did tonight.
Thanks again Azrobert for all of your help!
Navigation
[0] Message Index
[*] Previous page