New OBI 1.3 release... is it really ready this time, or keep waiting?
tome:
Quote from: AndyJ on September 30, 2011, 05:34:51 am
2532 never got past "preview" status, while 2575 is the official release. The enhancements shown in 2575 were actually available in 2532, but 2575 is supposed to fix some issues that users were experiencing with 2532. (In other words, the enhancements/fixes list only shows changes since the previous official release, and does not include preview releases).
But, yes, this release only lists the enhancements, and doesn't list fixes, although I know there are some since it fixed a specific issue that I was seeing.
Thanks. At the risk of stating the obvious, shouldn't bug fixes be listed? I can't think of a single preview or beta release I have been involved in that didn't list known and fixed bugs in release information...
Tom
RonR:
tome,
Obihai has never provided a real changelog with any firmware release.
tome:
Quote from: RonR on September 30, 2011, 09:43:43 am
tome,
Obihai has never provided a real changelog with any firmware release.
Sigh. ::)
Ideasmiths:
Possible minor bug, updating 1.3 2575 mess up factory configuration.
I have 2x Obi110, one in the office and one at home. Both are updated to version 1.3 build 2532 and have working setup.
Over the weekend, I noticed that there was a new version and I upgrade to version 1.3 build 2575 and suddenly all my calls out using the Line to my PSTN service reported 'number not in use', or there will be busy tone. Just before updating the firmware I was using it and the dial out were okay.
After checking through all the configuration, changed a few, rebooted 10 times, I couldn't solve the problem. So I tried to disconnect the physical phone and noticed that even with the phone disconnected, the Obi110 LED still shows connected. Using this hint, i plug the phone back and listened to the dial tone and it was emitting some strange buzzing sound.
I used the web panel to reset the phone to factory setting and then reentered my working configuration settings. From then on, the dial out worked as per normal. However, now plugging in the phone the LED is 'off' and only lights up after >2 minutes.
Maybe there is bug in the updating operation.
Come monday I will update the firmware of the Obi110 in the office and see if it repeats itself. In the mean time, those who encountered weird changes with 1.3 2575 may want to consider backing up the working configuration and do a factory reset.
Ostracus:
There's another thing I've noticed. Is anyone occasionally getting locked out of the web interface and have to power cycle the unit? I hope Obihai implemented a watchdog timer otherwise remote units are going to be a pain.
Navigation
[0] Message Index
[#] Next page
[*] Previous page