Ring tones OBI20

(1/3) > >>

Methias:
I really like my OBI202. I am however a little confused about the ring tone codes.
My setup ;
Sp1 is Inphonex with a ported line
Inphonex is set up to forward to my OBI202 and my GV account on sp3.
Sp2 & sp3 are GV numbers.
Line one and two use sp1 for all outgoing and 911.
Sp1 rings line 1 and both GV lines ring line 2.

I want different ring tones for each GV line so we can tell if it is my ladies line or mine.
First, I do not understand the ring codes.
      60;(.3+.2,1+.2,.3+4)
Is there a way to change frequency and length of or pattern of the rings?
All I can get it to do is a solid ring (just one long continuous ring) of one tone on line 2.
Line 1 rings correctly.

Thank you for any help offered.

drgeoff:
https://www.obitalk.com/info/documents/admin_guide/OBiDeviceAdminGuide.pdf page 163.

Methias:
Quote from: drgeoff on October 03, 2019, 11:46:28 am

https://www.obitalk.com/info/documents/admin_guide/OBiDeviceAdminGuide.pdf page 163.

That helps a lot, thanks.
For some reason phone line 2 just does a constant ring.
I created the following ring tone #10
      60;(.5+2,.5+2,.5+2,.5+5)
This ( if I understand)  will ring for 60 seconds with 4 quick stutters followed by a5 second pause and do again.
If I set GV sip2 to ringtone 10 and to ring on line 1 it works however when I set it to ring on L2 just one long ring.
I just know that I'm missing something basic but,,,,,

azrobert:
".5+2" rings for a 1/2 second followed by 2 seconds of silence. I don't consider that a quick stutter.

Try using the working L1 phone on L2.

Methias:
Quote from: azrobert on October 04, 2019, 08:45:09 am

".5+2" rings for a 1/2 second followed by 2 seconds of silence. I don't consider that a quick stutter.

Try using the working L1 phone on L2.


OK stutter, not the best word.  However I expect it to be silent for 2 seconds between chimes. No silence, just riiiiiiinnnnnnnggggggggg.
I have an AT&T 2 line cordless phone plugged in to Phone line 1 with a 4 wire phone plug that does both L1+L2.
But you got me thinking ::),  maybe two 2 wire cords plugged in to L1 and L2 on phone and my OBI202 will allow me to reverse the lines and see if the phone itself is the issue.

Getting some other phone cords and I will report back with the results
Thank you.

Navigation

[0] Message Index

[#] Next page