Ring tones OBI20
Methias:
Allright.
Thank you for your help.
The new just out of the box AT&T two line cordless phone system is messed up. The constant ring is the phones issue.
Calling support first to see if there's a simple fix or send back to Amazon.
Again,
Thank you.
I really like this forum and helpful members.
Hopefully I can pass some help on to others in the future.
;D
azrobert:
I had a phone that wouldn't ring with a short ring duration. Increasing the ring by a 1/10 or 2 fixed the problem. I realize it's a single 2 line phone and L1 and L2 should act the same, but it can't hurt increasing the duration.
Methias:
OK I got the timing of ring on and off.
Rebooted the obi202, while replacing the two phone cords with two newer (analog) two wire phone cords
Then rebooted the phone then the OBI202.
Did a backup,
Deleted both GV lines.
Rebooted again,,,
Added both GV accounts again
Went back to expert config and made up ringtones (a bit longer),,,
Tested,, , , and
It is behaving.
Thank you everyone who chimed in.
I read something about pitch or frequency but it seemed to be speaker tones. Dial tone, busy signal,,,,
Can I use something like this in the ring profiles?
480+3,620+3;60;(.75+1.5)
???
Is that even an option?
Again
Thank you
Methias:
Quote from: Methias on October 04, 2019, 08:06:05 am
Quote from: drgeoff on October 03, 2019, 11:46:28 am
https://www.obitalk.com/info/documents/admin_guide/OBiDeviceAdminGuide.pdf page 163.
That helps a lot, thanks.
For some reason phone line 2 just does a constant ring.
I created the following ring tone #10
60;(.5+2,.5+2,.5+2,.5+5)
This ( if I understand) will ring for 60 seconds with 4 quick stutters followed by a5 second pause and do again.
If I set GV sip2 to ringtone 10 and to ring on line 1 it works however when I set it to ring on L2 just one long ring.
I just know that I'm missing something basic but,,,,,
OK I understand why I had the constant ring when one called my sp1. That also (from my VOIP forwarding) was ringing in on sp3. both 1+3 were on serv profile A, ring profile A, and codec profile A.
Sp2 was profile B.
So by deleting both GV sp2+sp3 then reinstalling them reversed, I get the call on line 1 on profile A and also to my GV (now sp2) line using profile B. The continued ringing stopped.
Turns out that the OBI202 can handle two incoming calls simultaneously, and ring as coded, providing the calls use different profiles A or B.
Both on A causes uncontrolled ringing.
At least that is what I have found.
drgeoff:
Quote from: Methias on October 05, 2019, 10:48:37 pm
I read something about pitch or frequency but it seemed to be speaker tones. Dial tone, busy signal,,,,
Can I use something like this in the ring profiles?
480+3,620+3;60;(.75+1.5)
???
Is that even an option?
Again
Thank you
The pitch of the sound emitted by the phone's ringer is determined only by the phone. Not an OBi limitation, but a consequence of how phones work.
Navigation
[0] Message Index
[#] Next page
[*] Previous page