Trying to get the Cisco SPA504G set up with my obi200, but having difficulty getting it to register. The OBI device is registered, and setup with Google Voice. The ph line works fine. I followed the following instructions for the IP Phone setup:
• ITSP Profile D/General/SignalingProtocol = SIP (default)
• ITSP Profile D/SIP/ProxyServer = 192.168.1.10 (ie IP address of our SPA962 IP Phone)
• ITSP Profile D/SIP/ProxyServerPort = 5063 (SIP listening port for our IP Phone)
• ITSP Profile D/SIP/X_SpoofCallerID = yes (or checked, this will ensure we pass the caller ID through)
Next, create the local voice service that the IP phone will use as its proxy:
• SP4/X_ServProvProfile = D (We're saying use the ITSP D profile with this voice service)
• SP4/X_UserAgentPort = 5063 (Note:'you'can'choose'a'port'that'you'prefer,'just'be'sure'to'use'the'
same'port'number'throughout'the'tutorial
• SP4/X_RingProfile = B
• SP4/X_RegisterEnable = no (or unchecked)
• SP4/AuthUserName = 1001 (This can be defined by you, but needs to be the same on the IP Phone)
• SP4/AuthPassword = AnyPhonePassword (Once again, you can define this, but must be the same on
the IP Phone)
• SP4/X_Proxy = yes (or checked)
Configure the IP phone to register to the OBi and use it as it's proxy
On the IP phone, set=up the following parameters:
• EXT 1/Proxy = 192.168.1.20:5063 (ie: IP address of OBi202)
• EXT 1/User ID = 1001
• EXT 1/Password = AnyPhonePassword
• EXT 1/Register Expires = 60
• EXT 1/Register = yes
• SIP/Send Resp To Src Port = yes
The phone lines show solid amber lights, and registration error. Any help or guidance would be greatly appreciated.