Cannot change gains on OBi200

<< < (3/3)

drgeoff:
Quote from: RobertThompson on December 28, 2019, 07:41:20 am

Try this:

How to verify the current duplex setting.
On the Obi phone, do this:
1. Dial *** 0
2. Enter option 27 and press #
At this point the OBiMAN will read back the current value: 0 or 1
It should be 1.
If not, follow the instructions below.

Change the duplex setting to full duplex.
On the Obi phone, do this:
1. Dial *** 0
2. Enter option 27 and press #
3. Press 1 to set a new value
4. Enter a value of 1 and press #
5. Press 1 to confirm/save
6. Hang up
7. Wait for the OBi to reboot

That is likely to be a complete waste of time.  The "duplex" is the mode of the ethernet interface, not audio.

SteveInWA:
Quote from: RobertThompson on December 28, 2019, 07:41:20 am

Try this:

How to verify the current duplex setting.
On the Obi phone, do this:
1. Dial *** 0
2. Enter option 27 and press #
At this point the OBiMAN will read back the current value: 0 or 1
It should be 1.
If not, follow the instructions below.

Change the duplex setting to full duplex.
On the Obi phone, do this:
1. Dial *** 0
2. Enter option 27 and press #
3. Press 1 to set a new value
4. Enter a value of 1 and press #
5. Press 1 to confirm/save
6. Hang up
7. Wait for the OBi to reboot


SPAM.

Navigation

[0] Message Index

[*] Previous page