Phone port and distinctive ring setup - OBI110

<< < (2/2)

LeftRight:
b123guy,

OBi LINE port only has one set of parameters for ring detection, which potentially gives you a chance to detect regular ring, but not the distinctive one.

The regular US ring cadence is 2 seconds ON, 4 seconds OFF, so you can slightly change your ring detection configuration on LINE port to -

Physical Interface -> LINE port -> Ring Detection -> RingValidationTime:  1024 ms  (default 256 ms).

This change will work if the maximum ring burst length of your distinctive ring is less than 1 second. You might give it a try.

LeftRight:
Quote from: mikel on October 12, 2011, 06:33:41 am

Is there any way to passthru the distinctive ring so we can at least hear it?


As far as I know, you cannot pass through the distinctive ring, but you can configure how you want to ring the phone.

In the LINE port configuration page, you can find RingProfile and DefaultRing option. Once you change it, you will change the ring cadence for all the call coming through the LINE port.

RonR:
Quote from: mikel on October 12, 2011, 06:33:41 am

Is there any way to passthru the distinctive ring so we can at least hear it?


mikel,

The OBi doesn't use the ring voltage from ATT to ring the OBi PHONE and therefore can't pass it through.  The OBi does support 10 different ring patterns and each trunk can be set to use a different one.  The default values are:

Voice Services -> SP1 Service -> X_DefaultRing : 1

Voice Services -> SP2 Service -> X_DefaultRing : 1

Voice Services -> OBiTALK Service -> DefaultRing : 2

Physical Interfaces -> LINE Port -> DefaultRing : 1

Simply select the desired ring pattern (1-10) for each trunk.

There is no need to alter RingProfile's as A and B are identical by default.

Navigation

[0] Message Index

[*] Previous page