Bridged Audio Problem in Firmware 1.3.0 (Build: 2575)
Salvatore:
I upgraded to 1.3.0(2651) but I am still having troubles bridging calls.
Incoming calls come in via SIP. I am able to bridge incoming calls to:
a. ph (connected analog phone line) - no voice at all.
b. SP1 (dial out using SIP) - two way voice.
c. li (connected line to telco/pbx) - no voice.
with 1.2.x all of this is working fine. Is it possible to get the firmware image for 1.2 so we can downgrade? Is there any other alternate solution?
RonR:
Quote from: Salvatore on December 05, 2011, 01:58:46 pm
I upgraded to 1.3.0(2651) but I am still having troubles bridging calls.
Incoming calls come in via SIP. I am able to bridge incoming calls to:
a. ph (connected analog phone line) - no voice at all.
b. SP1 (dial out using SIP) - two way voice.
c. li (connected line to telco/pbx) - no voice.
The discussion in this thread is related to bridging Google Voice calls to a program running on a PC called SipToSis. The problem was totally confined to bridging calls between Google Voice and SipToSis. If you're not using SipToSis, then it's not related to this thread.
Quote from: Salvatore on December 05, 2011, 01:58:46 pm
with 1.2.x all of this is working fine. Is it possible to get the firmware image for 1.2 so we can downgrade? Is there any other alternate solution?
Once an OBi is upgraded to v1.3, it cannot be downgraded below v1.3.
Navigation
[0] Message Index
[*] Previous page