Caller ID not showing up

(1/3) > >>

Torino:
I am using OBI110 with Google Voice.  I have the OBI hooked up to the phone jack so I can use all the phones in the house.  Caller ID will show up on a ID box that has batteries but not on the phones that have the caller ID screen built in.  Does OBI not have enough power going to these phones to make the caller ID show up?

Stewart:
Try changing (one at a time) RingFrequency to 25 or 30, RingVoltage to 80 or RingWaveform to Trapezoidal.  If no luck, test with one problematic phone connected directly to OBi (no house wiring).  Using a non-default Ring Pattern can cause this problem with some phones.

Torino:
Quote from: Stewart on October 05, 2011, 03:58:57 am

Try changing (one at a time) RingFrequency to 25 or 30, RingVoltage to 80 or RingWaveform to Trapezoidal. 



How do I do this?

RonR:
Quote from: Torino on October 05, 2011, 11:02:39 am

Quote from: Stewart on October 05, 2011, 03:58:57 am

Try changing (one at a time) RingFrequency to 25 or 30, RingVoltage to 80 or RingWaveform to Trapezoidal. 

How do I do this?


Physical Interfaces -> PHONE Port -> Ringer -> RingFrequency
Physical Interfaces -> PHONE Port -> Ringer -> RingVoltage
Physical Interfaces -> PHONE Port -> Ringer -> RingWaveform

Torino:
I hate to be so stupid but where do I do this at?

Navigation

[0] Message Index

[#] Next page