Trunk group help with 2 obi110

(1/2) > >>

Momo:
Hi,

I need your help. I have 2 obi110's setup in 2 different locations.

I would like to know If I can add Obi2's line port to my Obi1's trunkgroup.

Actually, sometimes I need to use conference call (call 2 different countries). Once I place my first call from Obi1's line port, I can not place the second call as my line is busy. So i want my second call go through Obi2's line port. Is it possible to do that with trunkgroup ?

Thanks in advance for your help

RonR:
A trunk group is not for making conference calls.  Trunk groups cannot span multiple OBi's.

Can you normally make conference calls through your PSTN provider?  If so, is the second call iniitated using the Flash button on your phone?  If so, you might still be able to do so by enabling:

Physical Interfaces -> Phone Port -> EnableDoubleHookFlash : (checked)

Momo:
Actually, I can place 2 calls simultaneously with my PSTN line by pressing flash button(without OBI). But If I connect Obi, I can not place the second call. when I press twice the flash button, I have a dial tone (it stops after 2 sec) and nothing else.

Physical Interfaces -> Phone Port -> EnableDoubleHookFlash : (checked). => It was already checked.

Thanks for your help

RonR:
Are you doing a DOUBLE hookflash instead of a single?  A DOUBLE hookflash on the OBi's phone should get translated to a single hookflash on the PSTN Line.

Momo:
I've just edited my last post. If I press just once, I have "service is busy" message. But If I press twice the flash button, I have a dial tone (it stops after 2 sec) and nothing else.

Navigation

[0] Message Index

[#] Next page