Trunk group help with 2 obi110

<< < (2/2)

Momo:
Is there any way to setup speed dial to route the second call through Obi2 ?

Thanks

RonR:
In order to place a conference call through the OBi, you need to use the hookflash to initiate a second call.  Then you need to hookflash a second time to conference the original call with the second call.  Hookflash cannot be signaled or initiated from a Speed Dial.

Momo:
No actually, I would dial the first call normally. Then press the hookflash. After that, I would dial the speed dial to route the call through obi2 (something like *2154xxxxxx).

Maybe it's not possible. I just want to confirm this.

Thanks

RonR:
I haven't tested this, but I think you can do the following:

1. Dial party number one (using a Speed Dial, if desired).

2. Hookflash, placing the first call on hold and getting a new dialtone.

3. Dial party number two (using a Speed Dial, if desired).

4. Hookflash, conferencing the two calls together.

Either or both of the two calls could be placed using trunks on the local OBi or (with the appropriate configuration) on a remote OBi.

This thread describes how to configure two OBi's to be able to call out through each other:

Single-Stage Dialing Through Any OBi Trunk

Navigation

[0] Message Index

[*] Previous page