Calling through linked device

(1/2) > >>

dlehtin:
I would like to know if there is an easier way to call from my first obi212 to the second obi212 provider (freephoneline), that is located in a different location? this is my set up: 2 obi212 one located in Ontario and the second obi212 located in British Columbia. Ontario obi has google voice, callcentric. BC obi has google voice, callcentric, freephoneline. Callcentric is IP Freedom, Both google voice have incoming numbers.  I set up callcentric to access the auto attendant on the obi in BC and set the auto attendant to call using freephoneline. It is a bit of process to make a Canadian toll free call. Most of the toll free numbers do not accept international calls from the U.S. number therefor I am unable to use my primary google voice number. 

drgeoff:
You can call OBi to OBi over the Obitalk network by dialling **9 followed by the 9 digit OBi number. From there accessing the AA is just the same as you have done with the Callcentric SP.

azrobert:
OBi devices by default are setup to route outbound numbers to another device via OBiTalk network, however the receiving device isn't setup to route the call to a provider. I added a rule to the BC OBi212 to route the call to FPL. The format of the number is "1*1xxxxxxxxxx". The leading "1" is normally the speed dial number where the destination OBi number is defined. I hard coded the OBi number in outbound call route rule. The Primary Line's DigitMap is used to match the dialed number. This can be changed. The leading "1*" can also be changed, but must be unique. I'm assuming you know how to use OBi Expert.

OBi212 BC

Voice Services -> OBiTalk Service -> InboundCallRoute:
{510222222>(xx.):spx},{ph}

Change spx to the SP number of FPL (e.g., sp1)
Replace 510222222 with the OBi number of the Ontario OBi212

OBi212 Ontario

Physical Interfaces -> Phone Port -> OutboundCallRoute:
The 1st rule is: {([1-9]x?*(Mpli)):pp}
Change it to: {(<510111111:1>*(Mpli)):pp}

Replace 510111111 with OBi number of the BC OBi212

Dial 1*18005551212 from Ontario and the call will be routed to FPL

dlehtin:

I changed and used the Ontario 9 digit obi number, FPL is on sp4. Only the Obi in BC rings.

Voice Services -> OBiTalk Service -> InboundCallRoute:
{ON1234567>(xx.):sp4},{ph}

After changing the first rule,(test call) I then get a message "The number you dialed was rejected from the service provider reason is 503"
Physical Interfaces -> Phone Port -> OutboundCallRoute:
The 1st rule is: {([1-9]x?*(Mpli)):pp}
Change it to: {(<BC1234567:1>*(Mpli)):pp}

speed dial **1 in set for softphone so I changed the {(<BC1234567:1>*(Mpli)):pp}To {(<BC1234567:9>*(Mpli)):pp} but recieved the same message.

azrobert:
I made a mistake. The outbound call route rule should be:
{(<1:BC1234567>*(Mpli)):pp}

If it still doesn't work, post the call history from both OBi's.
You need to login locally to access the call history. Enter the IP address of the OBi. The default username and password are both "admin". Click Status then Call History.

What is the Primary Line and its DigitMap for Ontario?

Navigation

[0] Message Index

[#] Next page