Automated update using yellow triangle via the OBiTALK portal not working for me

(1/2) > >>

QBZappy:
I can not get it to update using this method. Has anyone tried updating using this method? Can you share your results please.


1.  Devices that have been added to OBiTALK will see an associated yellow triangle which can be selected to invoke an automated update process.

http://www.obitalk.com/forum/index.php?topic=9.msg15#new

earthtoobi:
i always use this and it works just fine.
Note that when device is online,it will let you update.
when device is offline, it points to  link in the forum.

QBZappy:
earthtoobi,

Thanks.
Does the OBi need to be auto provisioned by the OBiTalk portal for the green light to show? I think I have never had a green light. Only when I use the OBiAPP does the green light show for me. I always assumed it was because I configure the unit directly.

earthtoobi:
i have always used the obitalk portal and the green light and yellow triangle show up for me.
will leave it to others to tell you how it behaves when being managed locally.(my specualtion is that the green light should still show up)

infin8loop:
I manage my OBi110 locally (OBiTalk Provisioning/Method=Disabled).   The unit is registered on OBiTALK and I get a green light under Status on the OBi Dashboard by the OBi110 unit when it's connected.  I also get the yellow triangle when a firmware update is available.  I can update the firmware by clicking on the yellow triangle (I did this in the past).  For Build:2586 I downloaded the firmware file and applied it locally and the yellow triangle went away as would be expected.   I don't run a Soft Phone often, but when I do, I get a green light under Status when it's connected.  I don't drink beer often, but when I do, I prefer Miller Genuine Draft. 

Navigation

[0] Message Index

[#] Next page