Obi 110 bridging to Obi100 passing through to a PAP2
Dale:
the status shown in obi dashboard for SP1 is 'not configured'
yet the config has been added via the obiexpert screens
RonR:
I only deal with the OBi directly, so I can't help you with OBiTALK Web Portal issues.
In the OBi itself, SP1 status should be : Registration Not Required
Dale:
in the direct mode (accessing the IP address of the obi directly)
it also says: SP1 not configured
yesterday I was using this method to configure the OBI and then I found that it consistently refused to make the changes for X_InboundCallRoute so after numerous tries and reboots of the Obi I use the Obitalk interface and that accepted the X_InboundCallRoute change. Now that it is there perhaps I can go back to the direct access...
I'll check everything yet again....
Dale:
I notiec that userauth field was empty again so I entered some text,
now SP1 says registration not required.
But PAP2 still does not get to AA if I dial **0
RonR:
You have to use the OBiTALK Web Portal *OR* configure the OBi directly. You cannot alternate.
If you configure the OBi directly, you have to disable Auto Provisioning (that the OBiTALK Web Portal uses):
System Management -> Auto Provisioning -> ITSP Auto Provisioning -> Method : Disable
Failure to do so will result in the OBiTALK Web Portal reconfiguring your OBi with its settings.
Navigation
[0] Message Index
[#] Next page
[*] Previous page