Trying to register OBi504 SP service to Zultys
drgeoff:
Quote from: NetworkManagementServices on July 02, 2020, 04:05:37 pm
Quote from: drgeoff on July 02, 2020, 03:42:21 pm
Quote from: NetworkManagementServices on July 02, 2020, 02:28:55 pm
On another subject, I've been able to get the SP1 profile to ring through to phone port 1 for calls to the extension just fine, but I can't get it to automatically pick up the audio out (ao) port so it automatically activates speakers. Ideally what would happen with this device is that when it is dialed it immediately picks up the Audio Out and activates the PA for paging. Is this possible? The manual suggests it should be, but it looks like it is forcing me to dial additional input to activate it (e.g. extension 100).
I don't have a 504 and have never used the paging facility on any OBi. All I know is on page 32 of https://support.polycom.com/content/dam/polycom-support/products/voice/voip-adapters/user/en/poly-obi-3-5-series-ata-ag.pdf.
Have you tried putting just ao as the InboundCallRoute for that SP?
Yes, I tried ao, {ao}, and other variations of actually dialing something to reach ao. It seemed like it picked up the line, but I couldn't get audio to output on the speakers. I was going to try with different speakers in case my PC speakers just aren't designed to work with it.
The text at the top of page 49 mentions the loop-through from the Audio In socket. Use a standard 3.5 mm TRS plug to 3.5mm TRS plug cable to connect an MP3 player or smartphone and see if audio comes out of your speakers.
NetworkManagementServices:
So I am not sure what happened, but after testing different configurations, confirming that calls to the device successfully route out FXS1 with the ph value in the InboundCallRoute field of the SP, and then reconnecting my speakers it is now working (for now).
Setting the value to ao was the solution. Not sure why it wasn't working before unless there is just a sequence to enabling the configuration and connecting the hardware, because I definitely tried the exact setup that is now working.
Thank you very much for the responses.
Navigation
[0] Message Index
[*] Previous page