Not able to setup LocalPhone on SP2

<< < (2/3) > >>

RonR:
Quote from: Stewart on October 18, 2011, 04:19:41 pm

Localphone uses 00 as the international prefix and as of a few months ago, 011 was not accepted.


Then make these changes instead and dial international calls as 00 + country code + number:


Service Providers -> ITSP Profile A -> General -> DigitMap:

(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|<1aaa>[2-9]xxxxxx|<**2>00xx.|(Mipd)|[^*]@@.'@'@@.)

Service Providers -> ITSP Profile B -> General -> DigitMap:

(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|<1aaa>[2-9]xxxxxx|00xx.|(Mipd)|[^*]@@.'@'@@.)

where aaa is your local area code.

Physical Interfaces -> PHONE Port -> PrimaryLine : SP1 Service

sanxxx:
I am newbie, so sorry if I am doing this wrong.

I click "Enter Obi Expert", and then "ITSP Profile A General". On this page I am not able to edit anything. What am I doing wrong?

RonR:
I don't use the OBiTALK Web Portal, but you may find some help here:

OBi Expert Configuration (Introduction)

sanxxx:
I tried using the ip (192.168.1.xxx) to make these changes. But when i reboot, the changes go away.

RonR:
Quote from: sanxxx on October 18, 2011, 10:27:09 pm

I tried using the ip (192.168.1.xxx) to make these changes. But when i reboot, the changes go away.


You must disable Auto Provisioning or the OBiTALK Web Portal will overwrite your changes:

System Management -> Auto Provisioning -> ITSP Auto PRovisioning -> Method : Disabled

Navigation

[0] Message Index

[#] Next page

[*] Previous page