OBI Setup
ajzwilli:
I have an OBI 200 that I have been using successfully with google voice. However, google voice call screening was not working (wouldn't recognize me pressing 1), so I tried to do a reset of the device per something I saw on a forum. Now I can no longer get the device registered with Obi.
Here is what I have tried:
Removed Obi device from Google Voice
Removed all devices registered with Obi
Factory reset of Obi Device
Setting DNSServer1 = 4.2.2.2 (per Obi troubleshooting steps)
Firmware 3.2.2 (Build: 5921EX)
Under each scenario, the echo test works, I can access the device by typing in the ip address and I get "The number you have dialed **5xxxx has been sent to the server" every time I try adding it, but it times out. I have tried about 20 times over the last 12 hours. I see that some people have issue trying to register a device on weekends. I'll keep trying, but is there anything I'm doing wrong / else I can try?
Cudancp:
I am having an issue setting up google voice on my OBI202 it was working but was tryint to change the number so i removed my config setup from obitalk web site and now I can not set up google voice it continues to time out when i send my **5 plus code
Does anyone know if OBItalk registration is down ?
ajzwilli:
After roughly 24 hours of trying, it finally registered
MSRobi:
I'm glad I'm not the only one who can't add a device to obitalk.com. I have an Obi202 ATA which I just received today. I plugged it in, I see have an IP address, I dialed **9 222-222-222 and I can successfully do the echo test.
I did ***6 and I get back "SOFTWARE UPDATE NOT AVAILABLE", I am guessing that means that I have the latest software.
I create an account on obitalk.com, and do "Add a device", I enter the "**5 nnnn", get the system acknowledgement that the number has been sent to the server, and then it times out in 120 seconds. I tried 3 times and same thing.
Next, I get into my Verizon G1100 FIOS router, and I put the obi202 IP address into DMZ (essentially turning off firewall to device). Still no luck.
From obi system configuration, my device has:
Software Version 3.2.2 (Build: 5897EX)
Hardware Version 1.4
I even tried changing DNS to 4.2.2.2, and still no luck adding the device.
Anybody have any ideas? Do I just have to try again every 6 hours or so? Is there a known issue with Verizon G1100 routers/firewall?
MSRobi:
Correction...I have a Polycom Obihai OBi200 1-Port VoIP Adapter I purchased on Amazon.
Navigation
[0] Message Index
[#] Next page
[*] Previous page